Taig Tools

1/4" shank Edge Finder
2228

1/4" shank Edge Finder

1/4" shank Edge Finder. Use this in your mill for determining (and zero with offset) the exact edge of of a part to be machined. Can be used...
$13.86
Add:
3029 Manual Turn Lathe
3029MAN

3029 Manual Turn Lathe

This Manual 5C TAIG Turn Lathe has 1/2″-20 lead screws, is factory assembled, wired up, and ready to go. It has a 1/4 hp spindle motor and...
$1327.50
Add:
Taig 1" SPINDLE WRENCH
1310

Taig 1" SPINDLE WRENCH

Taig 1" SPINDLE WRENCH. For use on the Taig Micro Lathe II. Very thin to fit spindle nut behind a chuck.
$7.50
Add:
Taig 1053 3/4-16 Arbor
1053

Taig 1053 3/4-16 Arbor

1053 3/4-16 Arbor 3/4-16 Arbor used for mounting a 3 or 4-Jaw Chuck in the 5C spindle with a 17mm collet (not included). This arbor is NOT STOCKED at...
$13.50
Add:
Taig 3/4-16 chuck adapter
1221

Taig 3/4-16 chuck adapter

Taig 3/4-16 chuck adapter, adapts chuck to mill table
$13.86
Add:
Taig 4 jaw 3 1/4" dia. chuck
1030

Taig 4 jaw 3 1/4" dia. chuck

4 jaw 3 1/4" dia. chuck 3/4-16 thd mount jaws adjusted independently (reversable heat treated steel jaws  
$65.07
Add:
Taig 4040 - 5C Collet Set
4040

Taig 4040 - 5C Collet Set

Taig 5C COLLET SET (Includes 1/8", 3/16", 1/4", 3/8", 1/2", 5/8", 3/4", 7/8", 1", 17mm) Taig Tool...
$81.00
Add:
Taig 4041J - 5C 17MM Collet
4041J

Taig 4041J - 5C 17MM Collet

Taig 5C 17MM COLLET Taig Tool supplied low cost 5C Collet. 5C collets are produced in a huge varity of cost and quality. This is a good starter 17MM...
$9.90
Add:
Taig 5 Piece End Mill Set
1230

Taig 5 Piece End Mill Set

Taig 5 Piece End Mill Set (DOUBLE ended) 1/16,3/32,1/8,5/32,3/16 inch.
$48.06
Add:
Taig 6 piece high speed steel tool bit set
1095

Taig 6 piece high speed steel tool bit set

Taig 6 piece high speed steel tool bit set, left,right,45 degree,round nose,boring bar, and cut off
$29.79
Add:
Your IP Address is: 3.238.70.175
Copyright © 2021 Ramblin' Dan's Store. Powered by Zen Cart